![]() ![]() that scruffy looking pained thing.ĭone, just 3 screws to remove for removal of a rock solid rail. This shot is just the plain Flux lower with my rear rail anchor block screwed up on top in the back there. How cool is this thing I know the SIG P320 is off-roster, but some of you have one anyway. The threads have been milled to match the bore contour of the inner slide. I fabed up a left side cocking handle and put it in the most amount of meat at the front. Here is the front collar anchor made from stainless heavy wall pipe. The rail started out as a China made mid length AR narrow Key-mod hand guard. I'm not a big Tactical gizmo guy but have to say, its pretty cool since its well designed and as solid as it gets. Either to be able to buy the frame or have a full setup would be awesome, i know VFC hold the Sig license at the moment so hopefully they would reach out like they have done with KAC, BCM and FN. The Flux has the well designed spring loaded brace that literally shoots out of the collapsed position via a strong spring and self locks into a rock solid extended position. Im surprised to see that an airsoft company hasn’t made a copy/fully licensed version of the Flux Defense raider/ Mp17 yet. The Flux MP17 frame is for a drop in FCG from the Sig P320 in this case 9mm. Army M17, or SIG SAUER P320, and turns it into one of the baddest pistol-based SBRs weve seen yet. The Flux collapses to the size of a P90 and can hold up to 42 rounds on board if you use two 21-rounders. They are fun to play around with and seem very practical when a small PDW is needed. This is a job I did for a friend. It took a bit of imagination to pull off but it all gelled as I modified the parts to fit. What I will say though, is that I regret not getting one of these Flux MP17s a while ago.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |